黎开管热声振荡的主动控制研究

本文以黎开管内的热声耦合振荡为研究对象,设计基于主动补偿的适应性控制器抑制黎开管内的不稳定燃烧。试验以扬声器为执行机构来改变黎开管的边界条件,从而抑制黎开管内的热声耦合振荡。实时控制效果表明,本文所采用的适应性控制算法能够有效抑制因热声耦合产生的燃烧振荡,为实际动力系统燃烧振荡抑制提供了思路。     

绝对编码光栅的相位细分及其在位移测量中的应用

提出通过光栅条纹相位的精密测量,获取光栅高精度位移信息的方法。具体方法是对光栅图像采用多码道设计,用CCD二维图像传感器获取测量段光栅图像多码道信息。对最低码道图形的周期函数序列进行傅里叶变换、基频滤波和逆傅里叶变换获得光栅截断相位分布,其余码道信息提供相位展开的级次,以此获得测量段光栅的绝对相位分布。用光刻的手段制作了实用的绝对编码光栅,基元码道的尺寸是:27.36μm用于明条纹,27.36μm用于暗条纹,最小基元码道空间周期为54.72μm,光栅长度为14008.32μm。在步长近似3μm的位移测试中,与比对的标准仪器记录值比较,标准偏差为0.2057μm,精度在亚微米量级。重复性实验表明,位置测试的稳定性为0.09μm(标准差),得到600倍以上细分的分辨力。     

A novel simulation method to evaluate the collection performance of a monolithic active pixel sensor

A novel simulation method is presented in this paper to evaluate the collection performance of monolithic active pixel sensor (MAPS) devices for minimum ionizing particle tracking. A simplified 3D matrix pixel structure is built using the computer aided design software Sentaurus. The virtual device is then divided into hundreds of parts and an independent customized X photon model is involved in each part to simulate the conditions under ⁵⁵Fe radiation. After data processing and analysis, charge collection efficiency, collection time and diffusion conditions can be estimated in detail. In order to verify the reliability of the method, comparisons are made between the simulations and experiments. Although there are some defects, it can be concluded that the proposed idea is a feasible method for the evaluation of the MAPS collection performance.     

Multi-modal calculations of prompt fission neutrons from 238U（n,f） at low induced energy

Properties of prompt fission neutrons from ²³⁸U(n, f) are calculated for incident neutron energies below 6 MeV using the multi-modal model, including the prompt fission neutron spectrum, the average prompt fission neutron multiplicity, and the prompt fission neutron multiplicity as a function of the fission fragment mass υ(A) (usually named “sawtooth” data) The three most dominant fission modes are taken into account. The model parameters are determined on the basis of experimental fission fragment data. The predicted results are in good agreement with the experimental data.     

Theoretical investigation of the Gamow-Teller transition across N=40 shell

The Gamow-Teller transitions for pf shell nuclei with proton number less than 40 and neutron number larger than 40 were believed to be blocked, due to the full filling of the neutron orbit. However, recent experimental research shows that the Gamow-Teller transitions for these kinds of nuclei are not blocked. In this paper, we systematically calculate the GT transition of pf shell nuclei ⁷⁶Se in different truncations, and the results are compared with experimental results. It is shown that, due to correlations, the believed blocked GT transition occurs, and the shell model calculations reproduce the experimental GT strength. In addition, the electron capture rates in a stellar environment are calculated and discussed.     

Cascade-exciton model analysis of level density parameter dependence in proton induced fission cross sections of some sub-actinide nuclei

Fission cross sections strongly depend on the ratio of the level density parameter in fission to neutron emission, a_f/a_n. In this work, a cascade-exciton model implemented in the code CEM95 has been used to observe this effect for proton induced fission cross sections of tungsten, lead and bismuth. The method was employed using different level density parameter ratios for each fission cross section calculation. The calculated fission cross sections are compared with the available experimental data in the literature. It has been observed that a change of the ratio of the level density parameter, a_f/a_n, is necessary with the incident energy of the proton, to best estimate the fission cross sections in CEM95.     

Preliminary shielding analysis in support of the CSNS target station shutter neutron beam stop design

The construction of China Spallation Neutron Source (CSNS) has been initiated in Dongguan, Guangdong, China. Thus a detailed radiation transport analysis of the shutter neutron beam stop is of vital importance. The analyses are performed using the coupled Monte Carlo and multi-dimensional discrete ordinates method. The target of calculations is to optimize the neutron beamline shielding design to guarantee personal safety and minimize cost. Successful elimination of the primary ray effects via the two-dimensional uncollided flux and the first collision source methodology is also illustrated. Two-dimensional dose distribution is calculated. The dose at the end of the neutron beam line is less than 2.5 μSv/h. The models have ensured that the doses received by the hall staff members are below the standard limit required.     

Z charmoniumlike mesons

A brief review of the experimental situation concerning the electrically charged charmoniumlike meson candidates, Z^-, is presented.     

Design and end chamfer simulation of PEFP beam line curved dipole magnets

The design, fabrication and field measurement of 11 DC curved dipole magnets for the PEFP Beam Line have been completed. In this paper, a design method for a complex end chamfer using OPERA-3D is proposed. The conventional method for estimating chamfer shape is extended and applied to a curved dipole magnet by a coordinate transformation. Using the interface with CAD software, the complex end chamfer is modeled and fully determined by 3D simulation to meet the field uniformity requirement. The magnetic field measurement results are in good agreement with the simulation. The design considerations, field simulation results, end chamfer development process and measurement results are presented in detail.     

Design studies on the 4π γ-ray calorimeter for the ETF experiment at HIRFL-CSR

A high detection efficiency calorimeter which is used to detect γ-rays with energies from 1 MeV up to 10 MeV as well as light charged particles has been proposed. Design of the geometry, results of the crystal tests and Monte Carlo simulations are presented in this paper. The simulation results confirm that the calorimeter can obtain high detection efficiency and good energy resolution with the current designed geometry. And the calorimeter is competent for the future External Target Facility (ETF) experiments.